Flush Gas Cap
Pop a cap in your gas hole!
The wait is over! Flush Mount Gas Caps designed by Matt Hotch now exclusively available from Kindig-it Design! As seen on most every Kindig-it Design vehicle featured on Bitchin' Rides we are excited to offer these again!
Comes as a Non-Vented Cap for automotive applications, however, the cap can be vented by drilling through the machined hole on the side of the cap for motorcycle applications. Do not drill the vent unless for a motorcycle. The vent is not big enough to support an automotive application.
The cap itself measures 1.8" in diameter.
NOTE: This Gas Cap also has a cool feature if you’re into painting graphics on it. The graphics on the cap will return to the original position after being removed. Be sure the cap is on tight prior to painting or the graphics may not line up when tightened. Failure to do so is not the responsibility of the manufacturer or supplier.
** This cap does not meet EPA standards and is intended for off road and show use only. **